Anisotropic hot flow of textured Ti-6Al-4V sheet and its modification by superplastic pre-straining under hot stamping conditions
DOI:
https://doi.org/10.31224/8568Keywords:
Ti-6Al-4V, Hot stamping, Texture, Macrozone, Flow softening, Geometrically necesssary dislocationAbstract
The effects of crystallographic texture and macrozones on the hot flow behaviour of a 1.6 mm Ti-6Al-4V sheet, and their modification by superplastic pre-straining, were investigated by uniaxial tensile testing at 900 °C and 1 s-1, conditions representative of hot stamping. Directly heated (DH) specimens tested along the rolling, diagonal and transverse directions showed direction-dependent peak stress and flow softening: the transverse direction, along which most basal poles lie, gave the highest peak stress, whereas the diagonal direction softened least. Post-test SEM and EBSD revealed clusters of differently deformed primary α grains, Schmid-factor distributions and geometrically necessary dislocation (GND) patterns consistent with heterogeneous deformation associated with the macrozone structure. In a second route combining direct heating and superplastic pre-straining (DHS), pre-strains of 0.15 and 0.24 were applied at 900 °C and 10-3 s-1 before the subsequent 1 s-1 test, with total time at temperature matched to the DH route. Pre-straining weakened the basal texture, shifted the boundary population towards higher misorientations, slightly refined primary α grains and reduced residual GND density. During subsequent rapid deformation, the pre-strained sheet exhibited higher peak stress, less early softening and higher GND densities over the sampled strain interval, while the 0.24 pre-strain reduced local fracture strain. The results suggest superplastic pre-conditioning as a potential means of suppressing early flow softening in Ti-6Al-4V sheet.
Downloads
Downloads
Posted
License
Copyright (c) 2026 Famin Tian, Hao Wu, Nan Li

This work is licensed under a Creative Commons Attribution 4.0 International License.