Preprint / Version 1

Subtransus thermal route selection and constitutive assessment for Heat Stamping Ti-6Al-4V sheet

##article.authors##

DOI:

https://doi.org/10.31224/8809

Keywords:

Ti-6Al-4V, Heat Stamping, thermal history, viscoplasticity, phase transformation, finite element modelling

Abstract

Separating the soaking and deformation temperatures provides a means of tailoring the elevated-temperature response of Ti-6Al-4V sheet before rapid forming. Direct-heating (DH) and step-quenching (SQ) tensile responses were compared at subtransus temperatures and nominal strain rates of 0.1, 1 and 5 s-1. SQ from 950 °C reduced the flow stress relative to DH at the same deformation temperature, but its effect on hardening and softening was strongly rate dependent. The 950→800 °C route exhibited prolonged hardening at 0.1 s-1 while retaining substantial softening at 5 s-1. A 900→850 °C route provided a more balanced response, combining a lower flow stress than DH850 °C with reduced softening and positive apparent rate dependence. Post-test microscopy showed route- and rate-dependent α morphologies and image-derived α fractions consistent with the different thermal exposures and deformation times. A thermal-history-dependent constitutive formulation based on the Gavrus mixture framework was calibrated using the DH and 950 °C-based SQ datasets and subsequently assessed against the 900→850 °C route, capturing the principal stress, strain and rate trends over the calibrated strain range. A previously demonstrated cup with 1.8 draw ratio formed using the 900→850 °C route was further assessed at component level. The maximum measured thickness reduction was 12.7% near the punch corner. The simulation reproduced the overall thickness-profile trend and predicted considerable spatial variations in equivalent plastic strain and temperature during the 0.38 s draw. Post-form microscopy showed corresponding spatial changes in primary α morphology. The results identify the SQ900→850 °C route as a practical compromise within the tested matrix and demonstrate the importance of thermal history alongside instantaneous forming temperature and strain rate.

Downloads

Download data is not yet available.

Downloads

Posted

2026-11-16