Subtransus thermal route selection and constitutive assessment for Heat Stamping Ti-6Al-4V sheet
DOI:
https://doi.org/10.31224/8809Keywords:
Ti-6Al-4V, Heat Stamping, thermal history, viscoplasticity, phase transformation, finite element modellingAbstract
Separating the soaking and deformation temperatures provides a means of tailoring the elevated-temperature response of Ti-6Al-4V sheet before rapid forming. Direct-heating (DH) and step-quenching (SQ) tensile responses were compared at subtransus temperatures and nominal strain rates of 0.1, 1 and 5 s-1. SQ from 950 °C reduced the flow stress relative to DH at the same deformation temperature, but its effect on hardening and softening was strongly rate dependent. The 950→800 °C route exhibited prolonged hardening at 0.1 s-1 while retaining substantial softening at 5 s-1. A 900→850 °C route provided a more balanced response, combining a lower flow stress than DH850 °C with reduced softening and positive apparent rate dependence. Post-test microscopy showed route- and rate-dependent α morphologies and image-derived α fractions consistent with the different thermal exposures and deformation times. A thermal-history-dependent constitutive formulation based on the Gavrus mixture framework was calibrated using the DH and 950 °C-based SQ datasets and subsequently assessed against the 900→850 °C route, capturing the principal stress, strain and rate trends over the calibrated strain range. A previously demonstrated cup with 1.8 draw ratio formed using the 900→850 °C route was further assessed at component level. The maximum measured thickness reduction was 12.7% near the punch corner. The simulation reproduced the overall thickness-profile trend and predicted considerable spatial variations in equivalent plastic strain and temperature during the 0.38 s draw. Post-form microscopy showed corresponding spatial changes in primary α morphology. The results identify the SQ900→850 °C route as a practical compromise within the tested matrix and demonstrate the importance of thermal history alongside instantaneous forming temperature and strain rate.
Downloads
Downloads
Posted
License
Copyright (c) 2026 Famin Tian, Nan Li, Hao Wu

This work is licensed under a Creative Commons Attribution 4.0 International License.