Preprint / Version 1

Rate-dependent intra-ply shear of woven CF/PA6: Characterisation and modelling for thermoforming

##article.authors##

DOI:

https://doi.org/10.31224/8823

Keywords:

woven thermoplastic composites, bias-extension test, intra-ply shear, thermoforming

Abstract

This work develops a rate-dependent intra-ply shear model for molten woven carbon-fibre/polyamide 6 (CF/PA6) from bias-extension testing and validates it in U-shaped thermoforming. Tests were conducted from 190 to 270 °C, with five deformation rates at 230 °C and three specimens per condition. Below the PA6 melting peak, measured yarn rotation departed from the analytical bias-extension relation. Above the melting peak, measured and analytical shear angles remained close over 0–14 mm displacement, corresponding to an analytical shear angle of 39.7°. Across the tested molten-state temperatures, deformation rate produced a clearer effect on shear response than temperature. A continuous two-branch law was developed using shear angle and local engineering shear rate and fitted simultaneously to the five rate conditions. The model reproduced the measured shear response with a pooled RMSE of 0.0103 MPa and R² = 0.966 over 0–14 mm displacement. The law was implemented through VUMAT as the nonlinear 12-shear response of three-dimensional solid elements in a 15-ply U-shaped thermoforming model. Validation against surface yarn-angle measurements from two forming tests showed that the numerical profile reproduced the main centreline shear-angle variation across nine locations, with a mean absolute error of 1.89° and a root-mean-square error of 2.21°.

Downloads

Download data is not yet available.

Downloads

Posted

2026-11-17