Preprint / Version 1

A light brick from fly ash and coconut fibre that absorbs CO2: a short account of one worked example

##article.authors##

  • Van Sinh Duong Rides

DOI:

https://doi.org/10.31224/8837

Keywords:

fly ash, geopolymer, coconut fibre, CO2 absorption, lightweight brick, alkali activation

Abstract

Fired brick and Portland-cement concrete dominate construction at a heavy cost: brick firing consumes soil and fuel, and cement production emits roughly a tonne of CO2 per tonne of clinker. Meanwhile fly ash from Vietnam's coal power stations keeps accumulating. This short paper describes a construction material made from that waste: a fly-ash geopolymer reinforced with coconut fibre, activated with sodium hydroxide and sodium silicate, and designed to absorb CO2 during curing and in service. The composition is fly ash 60–85% (best 70–80%) with natural fibre 1–10% (best coconut fibre 1–3%), the remainder alkali activator at NaOH:Na2SiO3 1:1 to 1:3 (best 1:1.5–1:2). Fibre is pre-treated and cut to 2–10 cm (best 3–4 cm); the brick is pressed, soaked 5–10 days, and cured at 20–30 °C and above 80% humidity for 20–30 days, with optional CO2 sparging. One worked example is reported, exactly as stated in the source dossier: a 10 × 20 × 6 cm brick from 7 kg fly ash, 0.2 kg coconut fibre, 2.5 kg activator and 0.1 kg Sika R7N, pressed 3 minutes, dried at 60 °C for 1 hour, soaked 7 days, and cured at above 90% relative humidity and 25 °C for 28 days, with periodic CO2 sparging. The dossier reports for that brick a density of about 400 kg/m³, compressive strength of about 16–20 MPa, water absorption below 8%, and CO2 uptake of about 4.5 wt% in the first 24 hours. Those are values for one example brick, made once. This paper presents the material as specified, reports the example as reported, and sets out the validation tests still needed.

Downloads

Download data is not yet available.

Downloads

Posted

2026-11-19